Recent content by chriskbmx

  1. C

    new to briggs flatheads/ is this engine worth using?

    does anyone have a link to a good kart racing forum?
  2. C

    new to briggs flatheads/ is this engine worth using?

    Well if anyone knows a post about the bearings please lmk!
  3. C

    new to briggs flatheads/ is this engine worth using?

    also does anyone know of a post where they adapted the sealed bearings? And how deep of a slot should i cut for the fire slot?
  4. C

    new to briggs flatheads/ is this engine worth using?

    bump, any other tips?
  5. C

    new to briggs flatheads/ is this engine worth using?

    im getting on that!
  6. C

    new to briggs flatheads/ is this engine worth using?

    i guess a better point is where can i get the book, not on amazon.
  7. C

    new to briggs flatheads/ is this engine worth using?

    im ordering it now!
  8. C

    new to briggs flatheads/ is this engine worth using?

    anyone?
  9. C

    new to briggs flatheads/ is this engine worth using?

    anyone have an idea about intake ideas? I want to make power between 4000 to 7000, im curious if anyone has an idea for runner length
  10. C

    new to briggs flatheads/ is this engine worth using?

    so what your saying that sense it makes a sharp turn in the air flow, i should port the intake to allow air to flow that way more free? Also i do know better then to port the intake to a shine, ill probably leave at a 220grit finish, or maybe a bit finer. what advantages would i get from the...
  11. C

    new to briggs flatheads/ is this engine worth using?

    E36 can be very cool. So what kind of power am I looking at with this formula. with the head ill cut the head .030 Maybe a slightly smaller gasket if they make one? Fire slot everything nice and polished up, no hotspots here lol a tuned exhaust cheater 94ss cam billet flywheel 2 exhaust...
  12. C

    new to briggs flatheads/ is this engine worth using?

    I will be getting the head machined for free. Can anyone tell me about the fire slot, or have a picture? How far can I rev this motor with the bushings? or is it just as easy as milling the block to fit bearings? Also what size carb should I be looking for?
  13. C

    new to briggs flatheads/ is this engine worth using?

    There also seems to be excessive endplay on the crank. Anyone know the spec? Also what would cause the endplay, just a bad bearing?
  14. C

    new to briggs flatheads/ is this engine worth using?

    yes exactly what i mean. You unswrew the top cap and the throttle comes out. if that works i have a carb of a pw80 dirtbike that might work well. Do you have a link to boring the block to accept sealed bearings? Im assuming the same crank will work?
  15. C

    new to briggs flatheads/ is this engine worth using?

    So it is deffinitly possible to just remove that cam, use another cam and just cover the hole? Do you guys have a link to what carbs I should be looking for, I have access to a couple small cc motorcycle engines, but they use cable through the middle carbs(I forget what this is called) I...
See more
Top