Recent content by chasgas

  1. C

    clutch question???

    6.5 hp, thanks for the advise. sid, as i posted, "i've got to change the subject". not one comment on how to blow out a bolt, axle, pin??? you all knew that method, eh??? you can type to shut up but not one hey, thanks for the effort? po boy's reponse to original question: OK....NO!!!! You...
  2. C

    clutch question???

    sid, you sir set a great example and honestly, the community would be hard pressed to outsmart you. i would bet about the same time the v belt and v pulley were invented somebody realized a tensioner on a spring was the best way to keep the v belt tight. not a clutch, simply a third pulley...
  3. C

    clutch question???

    why? why take the time to type "we're more experienced than you"? tearing someone down somehow lifts you up? we have a very limited amount of time on this earth, better spent in the light. the only reason i started this thread is because i had no experience with kart drive-lines, specifically...
  4. C

    clutch question???

    sid, 40$ more to go the tc way. agh. i would never have thought a tc drive would go for years. safety, supervision and not much speed! but don't tell them... all finished here......... thanks sid and all........................... chas
  5. C

    clutch question???

    sid, we're just going to have to agree that we disagree. i just looked at that driver to see if i could put a bolt through it and convert it to a regular pulley. i notice one of the castings with the "shoes" (sorry, non-karter here) hooked to the pulley is broken. planned obsolescence strikes...
  6. C

    clutch question???

    bob58o itsid thanks for your time, knowledge and the "facts" i was looking for. i have to agree with both of you that mixing one half of a torque system to a regular type pulley would be far less than acceptable. it came with the cart and i thought/hoped somehow i could make it work. throttle...
  7. C

    clutch question???

    when i signed up yesterday this is what your site sent: As forums go, DIYGK is as chilled out as you are going to get. There are very few rules, but we enforce the ones that we do have pretty strictly. This is to keep the forum family orientated. Most of our members are below the age of 20, and...
  8. C

    clutch question???

    well, po boy has an answer. thanks so much. in the one day here reading various threads i've noticed your repeated manner of dealing with members. i'm more than three times the age of the average member here so bullies and their tactics have little to no effect on me. again, thanks but no...
  9. C

    clutch question???

    sorry but you either don't understand the question or you didn't take the time to read??? can i put a plain old pulley on my motor, build a tensioner type clutch setup, drive the variable pulley on the jack shaft and it will work as it was designed (just as it would with the centrifugal clutch...
  10. C

    clutch question???

    hey shaft is 1". i have the "expandable pulley" on the jack shaft (called a variable driver pulley i believe). i do not have the centrifugal pulley that should go on the motor. it does have a jack shaft that runs to the axle using gears and chain. i'd rather not buy a centrifugal clutch pulley...
  11. C

    clutch question???

    hey, new here. bought a sears/murray go cart less motor. got the jack shaft with driver pulley (adjusts) but no centrifugal clutch. my question is "will a tensioner type clutch work with the variable driver"? thanks, chas
Top