Recent content by cadams23

I appreciate all the help guys. She’s running good and I’m a full blown kart addict now.

Appreciate the info. My game plan right now is to get the tc today and line it up on there to see what I’m working with. I still have the jack shaft if need be. I would like to make the tc work without the js, get a 60t axle sprocket to the 10t on the tc, and get rear tires same size as the...

I have this kart for about 3 days and have learned quite a bit. I found a gear ratio calculator and learned how it calculates. I thought this forum was for helping ppl out, and don’t think I’ve asked anything too stupid for being into this for 3 days. Not sure why you have to post a dick ***...

Sprocket on axel is 40t. Clutch and jack shaft have been removed. I don’t need the jack shaft with the tc correct? Tires are 18x9.5-8

Looks like chain says 402. Sprocket on axel has 40t I believe. How would I adjust or remove this sprocket if needed? I don’t see any set screws or anything.

Ok cool. Let’s say I get a 30 series tc. I have a 40 chain and will use the 10t sprocket on the tc. What type of axel sprocket should I run?

I really appreciate all the info. My dad got this kart at an auction and put some cosmetic money into it and the tires. I think what I’m going to do is get a predator 212 and a torque converter. My son is not old enough to ride it yet, so I will be the one driving. will a 212 and a cvt carry...

Thanks guys. Here’s some pics of the setup.

Thanks for the info. I just replaced what was on there with something similar. Can you elaborate a little on the CVT or possible send me a link to something that would work with this setup?

Hi all, first post here. I have what I believe is a Manco Hyper Fox. 126cc Robin Subaru engine. When I first rode it it seemed like clutch was slipping and it was smoking. I ordered a clutch on Amazon. 3/4” 10t. FYI I didn’t not disassemble the new clutch and did not lube, grease or oil...