Recent content by bwiggs2

Ok so i have a mini buggy that has a gy6 150 on in, it goes too slow and the take off is bad. What should i do to make it faster. Im thinking about buying this off of ebay...

Thanks everyone for advice

I wish I could find someone to do it for cheap haha.... Thanks for the help everyone!!

Ok I'm going to sand it, prime it and then paint it...I'm just worried about the part that is wire wheeled showing

Taking all the paint off just takes absolutely forever.. I want to get it done in like a week

An hour? I have worked on it like 5 hours and got like a fourth the way done if that.. The wire wheel takes FOREVER

What sand paper should I use? I want to get it done fast

One guy told me to just get 400 or 500 wet/dry sandpaper and sand it then prime it then paint it..will that work?

I have a 150cc mini buggy. I am going to paint it and started wiring wheeling it but it is taking forever, I have like a fourth of it done. Can I just sand it and prime it or will the part that is wire wheeled look bad. What would you do. Thanks blake

Ok it is not cutting out now, it sounds like it is runnin good and can finally climb hills but it will only go 15 mph, something is still not right because it doesn't have the power it should. What could it be now?

well i cleaned the carb and took the jets out and cleaned them and cleaned it all really well but do you think i should clean it again?

Any other ideas? thanks

I think im going to buy a new choke and rebuild the carburetor. I cleaned the carb and everything but it has been sitting for 3 years

It wont even run now, it ran last night but i tried it this morning and it wont even run. HA HA

It has a electric choke that is on the carburetor