Recent content by brandonhuston

they are vank wheels and measure 8 3/4" wide Sent from my iPhone using Tapatalk

Hey anderkart! I'm in need of new tires for my shifterkart you helped me get going! It currently has Burris 11x6x6 in the rear. I measured the rim and it's a little over 8 inches wide. So the tires is stretched 2 inches. I was wondering if it would be ok if I put on 8inch wide slicks? I'm also...

Look up go kart fuel tank on eBay. They have a bunch of different sizes. Mines the 5qt tank. It's listed for $79. I made an offer for 70 and got it. It's really good quality! Sent from my iPhone using Tapatalk

Alright I'm on the last part of my build. And probably the hardest part. The clutch. I'm not sure what to use to mount the clutch lever and also the cable. It needs to go on the shaft so it can spin with it. Any ideas? Sent from my iPhone using Tapatalk

Also fabricated a bracket using an aluminum pipe to hold my silencer still. I flattened the ends and drilled a hole. Holds perfect. Sent from my iPhone using Tapatalk

Never mind. It's tapped! Sent from my iPhone using Tapatalk

I'm a little afraid that my fitting won't fit where the carb mounts. Could I tap into the exhaust side? Or does that area have to much heat for a brass barb and hose? Sent from my iPhone using Tapatalk

So I know I need an npt fitting, and that I need to drill a hole and thread it and screw in the fitting and all that. But as at as the location I am stumped Sent from my iPhone using Tapatalk

Thanks man! I'll just cut it to the length I need and tap it with an 8mm. I was talking about the pulse line the you tap into the intake/carb. Sent from my iPhone using Tapatalk

I finished up painting my kart and I got my engine mount in and it's a perfect fit! I got it mounted on the kart along with the new sprocket, chain, j arm, exhaust, and gas tank. Look like my shifter rod is to long. Could I cut it? I'm not sure if it's threaded all the way through or not. I'm...

Huh, that's odd. It does fit though! But it is very tight! It's weird though because it came shipped from Azusa instead of gokartgalaxy. Also I just got my pro circuit exhaust and silencer in the mail! Sent from my iPhone using Tapatalk

I don't know the name or part number. But it's made by Azusa engineering! I believe it's a mini bike hub. And then the sprocket of coarse is a 428 split sprocket. Why do you ask? I could call and ask if you'd like to know exactly. Sent from my iPhone using Tapatalk

I also got my hub and sprocket in the mail. I ordered a 5qt aluminum fuel tank and 15ft of clear fuel line (I got clear instead of colored so I could see the fuel). Also have a round mikuni fuel pump in my kart I'm about to order. Also as far as my chain goes. On shark shifter they sell them as...

Okay. And thanks! I thought so to! So does the shifter arm work kindof like a hinge? It looks by the way it mounts by the two bolts that it would swing to shift. But I'm sure once you have the tie rod on it it would feel different. Sent from my iPhone using Tapatalk

Oh gosh, I didn't know I needed a hub:( I figured I'd just weld a price of metal coming off my frame that I could bolt it to. here's a pic of the shift lever. I hope I didn't mess up by ordering them:( Sent from my iPhone using Tapatalk