Recent content by BIG-O

OK, I think i'm gonna sell my cart, what would be a good price? Only thing is the stuck master cylinder and the engine wont idle good...you have to give it gas to stay on.

I blew air with a bike air pump into the caliper and it seems to work. While turning the axle by hand I have my wife pump air into caliper and I can feel it stop. Now I just need to get this piston out on master cylinder, I will take it somewhere where they have an air compressor. I have...

Should I just remove all the brake system and buy a new kit? Like this one... http://www.ebay.com/itm/MCP-Hydraulic-Brake-Kit-w-Rotor-Caliper-for-1-Axle-for-Racing-Kart-Fun-Cart-/190701817324?pt=Race_Car_Parts&hash=item2c66b6cdec&vxp=mtr

Older pictures but good for reference.... Steering mechanicals.. Briggs engine... Seat... Sproket & chain.... Cut off switch....

Have not tried the air, don't have an air compressor. Will try this week. I have tried boiling in water and vinegar with no movement. I did try pushing it in with a bolt and hammer and it did go in further. I would like to still use this brake system even though I know its old and outdated, it...

I purchased the red mineral brake fluid, the Hurst Airheart rebuild kit, but the dumb piston is stuck. Does anyone have any idea if I can use a replacement master cylinder instead of this vintage one? I can sell this whole setup pretty much for a new one looks like. Any one have an old master...

Got my table cut, welded, & painted... http://i857.photobucket.com/albums/ab131/Omar_Cabello/IMG_20140205_163424_zpsbfeaf054.jpg http://i857.photobucket.com/albums/ab131/Omar_Cabello/IMG_20140205_163436_zps93467b19.jpg

Yes the exit part with the teflon tape and nipple...

That little nipple on the master is stuck also. I tried to remove it but it wont budge. Still soaking in WD-40 to see if the piston magically pops out.

I see that as posting the same question on different forum sections....Oh well I guess I am wrong.... I will do better I guess.. Can the Admin remove all the ugly negative posts so my thread looks nice and clean?

Be respectful to moderators and other forum members. "Flame Wars" will not be tolerated. Keep your posts "family friendly". If Grandma would blush reading your post, then don't post it. Use the search function. If you have a question, it has probably been asked before (Or look HERE) No double...

Landuse please uncheck yourself from this thread.

Building a lift/table on wheels this weekend........... Drawing the plans (ACAD) with dimensions for the lift....If I ever sell the cart I can keep the table as a work bench....I am gonna make it sturdy...

Still tearing it down...Bunch of mess all over ...

My carb set up...Should the choke be plugged up like that?