Recent content by Battleboar

Or a busted spring on the driven unit. When I turn it by hand one way and release it....it should snap back correct ?

Could a belt slightly less wide be the answer ?

Everything was working fine on the run stand but as soon as I finished installing the motor it engages the wheels. I thought maybe the chain was too tight so I purposefully left it loose just to see if it helped and it made no change. The copper race is on and I'm running the green spring on...

Btw way all parts were ordered new

I am part of the way through a cart build for the lil guy and after fighting and fabbing brackets to mount the tav2 kit it engages immediately at an idle. I have backed the idle down to where it barely stays running and loosened the chain to where I have almost one link too many. I have not...

Thx for the heads up. I will see if I can find him

Would I need to change the location of the axel sprocket if I installed the tav2. Or would it most likely line up correctly. Since the drive sprocket is located between the pulley and motor. I know a definite answer isn't really possible but I'd settle for an experienced guess

54 on the axel sprocket

here are the pics of model # and general setup does have a dingo like face on the steering wheel hub it currently has 19x7.5 r8 on rear and frt 145/70 r6 w/ 10t sprocket clutch assembly the generic model 386 manual I found calls for a 9t sprocket with 22x11x11 rear tires and the frt are...

Also what if any name goes with this model. Dingo, fox etc...

I recently bought a manco model 386 -092 Equipped with a new predator 212 that kept burning clutches according to the precious owner, it apears to have been equipped with a torque converter set up at one point judging from the jack shaft housing on the motor mount plate. I want to return to a...