Hi guys i have finished my kart and wired it all up and i was able to run it for about 25min! Thank you for your help.
I have a charging question, i haven't tried yet but would it be alright to connect my 3 12v batteries in parallel to my 12v agm battery charger?
I think it would be alright but...
Hi, i think that wont be good as 3000/ 24 =125 amps, you will have a lot of power but very low run time. Unless you spent a few hundred on batteries with really big ah rating
Sent from my iPhone using Tapatalk
I need a series wound motor with 4 terminals A1 A2 S1 S2 for my controller, i have an old used one in mind but does anyone know where i can get one that is over 2hp (1400w)? For around £150.
Thanks
Sent from my iPhone using Tapatalk
Im using the same motors in parallel so they will produce same rpm. But is it better the way shown in picture or to have the motors powering different sprockets connected to the axel by individual chains?
Sent from my iPhone using Tapatalk
Im using two motors, is this a a good or bad method? Would it be more efficient if the two motors were powering individual sprockets attached to the axel?
Sent from my iPhone using Tapatalk
Ok thanks,i got the controller. But i also need a throttle, can you please suggest what types of throttles are best for the Curtis controller?
Would something like this work? http://www.ebay.com/itm/171125691520
I dont want fancy led indicators i just want one thats best for no more than £50...
Thats an awesome controller much better than the rubbish one i found lol.
What is the maximal watt rating for that controller?
Sent from my iPhone using Tapatalk