Recent content by 88d50

ya i was gona make the adapter out of aluminum. where do you get one of those filters? and whats the outlet size?

i got a briggs 6hp and its missing the whole air filter assembly. rather then buying a new one i was thinking of makeing one. but i dont know what type of air filter i could use. has anyone ever made an intake? or maybe got an idea of what kind of filter i could run? i wanted it to sorta look...

its a 6hp intek 190. ya the site doesnt say anything at all about it. i was guessing it was for the california emisions stuff cause my buddy has a lawn mower that said not for sale in california. ill give them a call. thanks.

im trying to order a bunch of parts that were missing off my briggs motor and on the parts list for that motor theres 2 different part numbers for jets? how do i know what one to get? or should i just call them? the model number is 121432-0119-e1 and the two different part numbers are 690048 and...

the old side cover had an o ring but the hole in it was bigger then the bearing so maybe the oil could go from the motor to the pressure pump? but if i left that cover on and cut it for a chain guard i would still need the seal. im gona take the whole engine to the mower shop tomorow to see if...

there mechanical brakes. i got 2 of the bikes for free so i wante to use all 4 wheels off both bikes if i could. the bikes had a tiny little 2 stroke motor.

whats pto? so you just take off that side cover and install a seal there? then put the cover back on? where do i get the seal from?

would those disc brakes be enough to stop if i only run one of them? each wheel has a rotor but they run off a cable like a bicycle so my easiest option would be to run only one.

ya it might be junk but i got it for free so if it doesnt run oh well. anywas i got those 4 bolts off no problem just had to use an allen socket. heres a pic with everything off the crank. one question will oil leak out of there? the peice that came off had an o ring and the 4 allens had o rings...

whats the difference between dead and live axle?

the studs that come out both sides are 3/8" i was thinking maybe take out the bearings and change them to ones with a bigger id.

im going to build a go kart and i got these too little motorcycles for free but i plan to use the wheels off them for the kart. but the axle bolts seem kinda small. probably just a little bit bigger then a bicycles axle. how thick are axle usually on a go kart? i wana use the wheels because they...

ya i pried that thing off the shaft it wasnt too hard to get off. and ya its a 3/4 keyed shaft so im good to go. and just like you said theres 4 allen bolts holding that cover on there but there tight as hell. one more question how do you drain the oil out of this thing? and what type of oil...

haha that made me laugh. thats the plan though. i went to the mower repair place but they were closed. another question though when i start this thing is it gona jump all over the place since its not bolted to anything?

so i need a float bowl and air filter. what does that hose from the ohv thing go to? my next question was going to be about that out put shaft. heres a pic of it. do i need to take all that off and how do i get it off?