View Single Post
  #50  
Old 10-09-2012, 10:49 AM
oscaryu1 oscaryu1 is offline
Senior Member
 
Join Date: Mar 2008
Posts: 2,767
Thanks: 6
Thanked 148 Times in 60 Posts
Default

Quote:
Originally Posted by AMMFAB View Post
i rarely lower the floors on any given head. i lowered the floors on the inlet of the intake port and the outlet of the exhaust port on the clone head just enough to even them out and no more. i can only assume u say u would see this on a high revver because it looks as though hogged the ports out but theres a taper effect going on sir. funny thing is that engine will see north of 8k though.


mike
Yes, looked a bit hogged out. For 8k I can see why though I do think dropping the port floor is the wrong way 'round. I can see your taper but I can also see a sharp increase in area from so much bowl blending.. you'll get some flow separation at lower rpms. Remember a banana port will always flow more..