I need some help

[Randy46843]

So I’ve started building a go kart/buggy type thing and I’m just a little confused on how I would put the front wheels on. This is what I’m workin with anything helps

 

[Randy46843]

So I’ve started building a go kart/buggy type thing and I’m just a little confused on how I would put the front wheels on. This is what I’m workin with anything helps View attachment 146886

Also there is little holes for cotter pins on the end of the bar for the front tires

 

[Denny]

Actually you need to cut that front axle off and start over. Scratch that, just cut the spindles and tubes off and weld on some c brackets and buy some GoKart spindles.

 

[ezcome-ezgo]

 

[Master Hack]

Actually, I used a similar axle on the Naughtagator. There are no bearings, the wheel has(d) greaseable bushings that run on the spindle. The wheel has a zerk fitting. That thing that looks like a bearing is a dirt/dust shield thingy. That is typical of the (cheap) lawnmower axles I have seen.
Nice clean place to paint, BTW.