View Single Post
Old 04-24-2019, 01:42 PM
frostyflammable's Avatar
frostyflammable frostyflammable is offline
Senior Member
Join Date: Oct 2016
Location: Dallas, TX
Posts: 348
Thanks: 45
Thanked 123 Times in 89 Posts

Honestly never counted the turns... I usually lift the driven axle off the ground, turn the idle screw a few turns and start the engine. If it does I add a couple of turns until it doesn't and then turn down until the idle is about right. I never measure mine with a tachometer I just go off sound.

When you say the long tube I think you mean the emulsion tube, the main jet is the piece the screws out. Normally just a small bang on it gets it out, or you can carefully push it form the inside to get it out. Def needs to come out to be cleaned.