View Single Post
Old 01-24-2010, 06:08 PM
nerfo's Avatar
nerfo nerfo is offline
Join Date: Nov 2009
Location: Madison, WI
Posts: 85
Thanks: 3
Thanked 3 Times in 3 Posts

The length of the shaft is where "getting creative" comes into play. Make a bushing that fits inside a pulley, and that a 5/16" bolt fits through, use a big washer under the head of the bolt to hold the pulley on, then use the pulley as both a chain guide/clutch retainer! That's one possible idea. Of course it wont work on EVERY engine/clutch out there, but a guy who really wanted it to work could probably get something like that going on anything if he really wanted to.
People do this when I talk ut: