Hello everyone. I bought a used non-running BaJa 150 4 wheeler with a gy6 engine. I ordered a whole new wiring harness and rectifier, cdi, and whatnot. Anyway im looking at these rubber lines and im not sure how they properly route. I'm also confused about the 2 what I think emissions parts are. one is the black plastic "im thinking charcoal canister" looking thing and its the attached to that metal valve which then goes to a metal line to the exhaust. also im not sure where the big fat rubber busted up tube thats sticking up near the fuel shut off goes. Theres no petcock that ive been reading about. I think whoever owned this replaced the carb but didnt run the lines correctly. any help is much appreciated. I've looked and cant find a setup like this.