I did miss read the instructions, as for date and password.
I finished the welding of square tube to a rescued tubular roll cage today and threw the first coat of paint on it. I'll be there doing more tomorrow and repost proper entry photos.
You will have to decide if I'm half way done or not.
As my title says this car will race in a specific class, with a tech sheet check before we are allowed on track. We are in MR1 class on dirt with Honda 6.5 HP rule set.
http://www.tricountymicrod.com/wp-content/uploads/2010/02/2010-Planbook.pdf
Ours will be 4 link rear suspension, coil over clicker shocks, live rear axle, solid front axle fully suspended with coil over shocks.
Very few parts come from last years car. over sizing everything from axle dia. to heim joint and radius rod size. 11 tooth clutch to 58 tooth gear. hope to see 30+ mph. April 27th is first practice, May 10 is first race tick tick.
I finished the welding of square tube to a rescued tubular roll cage today and threw the first coat of paint on it. I'll be there doing more tomorrow and repost proper entry photos.
You will have to decide if I'm half way done or not.
As my title says this car will race in a specific class, with a tech sheet check before we are allowed on track. We are in MR1 class on dirt with Honda 6.5 HP rule set.
http://www.tricountymicrod.com/wp-content/uploads/2010/02/2010-Planbook.pdf
Ours will be 4 link rear suspension, coil over clicker shocks, live rear axle, solid front axle fully suspended with coil over shocks.
Very few parts come from last years car. over sizing everything from axle dia. to heim joint and radius rod size. 11 tooth clutch to 58 tooth gear. hope to see 30+ mph. April 27th is first practice, May 10 is first race tick tick.