Search results

-18*f here in east central ''ice box Iowa'' this morning,, ''without the wind chill'' …. :eek:o_O

Somebody put ''a lot'' of thought in this.... ''Love the ''HEMI'' !

''Very good'' over all cond. vintage Coyote race Kart ''Sprint bumpers''. They are bare metal & ''very stout'' solid steel. Front center to center down spacing is 7 1/2, & back side to side is 18'. Center to center on the rear bumper is 24' They just need waxed/polished, painted,, or plated...

Vintage ''very light weight'' 4 spoke steering wheel made by PRC. Width is 13.5, & height is 10''. It only weighs 14.8 ozs. Has some normal paint wear , but condition of the aluminum is excellent. Would look ''killer'' sanded down & polished. Asking 40 bucks,, which includes shipping to...

Looking for an Enginetics ''904'' master cyl. lid, w/ 4 corner screw holes. Would prefer the up grade aluminum one, but would settle for the OEM plastic. Send me a PM. Thanks, Ian

My Buddy & I just got back from a ''long'' road trip to pick up these 2 vintage Kart chassis. Mine is an 80''s Coyote ''Bullet'' sprint. His,, is an early 80's, Margay 'Xpert'' sprint. They are well used, but for 250 bucks ea.,, it was more than well worth the trip. They are ''each'' going to...

All the aluminum work ect. I did by hand. My GX-200 Buddy's Tillotson 212 Same Buddy.. 48v - 1800w BLDC, ,w/ 2 - 13s -3p packs in parallel. AUW is 75lbs.! It does 35+mph , with 6.1-1 gearing,, & runs around 45min.,, with a 200lb. Guy on it. Motor just gets warm,, & controller stays...

My Buddy & I are picking up a couple of vintage racing kart chassis later this week, for electric conversions. If you want to know more about me,, just check out my info.;) Regards to all, Ian