Search results

Rooster just fyi you dont need spacers if you dont want them. I purchased a new hex axle for my kart which didn't have a weld stop like my original. New brake rotor and bearings. All you need is 1 inch axle collars from amazon on both sides of each part your securing. 2 for brake rotor, 2 for...

My govenor is still connected. As far as the throttle cable, I ran the cable housing through the clamp and tightened, then ran the actual cable through the barrel nut and tightened/loosened with a 10mm wrench and screwdriver.

Here is my set up

I have a manco 710e with hex axle. This was the original set up. I believe that welded piece was just to stop it from moving to the right. The spacers kept it from moving left.

I have a 420 with throttle set up. Can you post pictures on how yours is set up?

Hey everyone, I plan on converting my mechanical brakes to hydraulic brakes. After looking at mcp calipers and master cylinders I noticed that they offer both single and double line caliper and master cylinders. Is there a disadvantage to one as opposed to the other. Would a double master...

I purchased a kart recently that came with 22 inch knobby tires in the rear and 16x6.5-8 tubeless tires in the front which don't hold air very well. I plan on using this kart for off road purposes but cannot seem to find the front tires anywhere. Any recommendations on tire size or tread pattern?

Hey everyone, I have a stock predetor 420 and plan on removing the govenor. If I do this will I have to change my gear ratio?l to compensate for the rpms?

Hello everyone, I recently purchased a manco phantom and a stock redator 420 with a go power sports 40 series torque converter kit. The kit comes with a 10T clutch sprocket. However, I do not know what drive sprocket to run with it. I have read that running the wrong ratio can burn clutches. It...