Search results

Hi, Just completed mod2 cam, rod & flywheel installation on my sons Tillotson 212. Already had stage 1 with header and muffler. Not sure but the muffler seems to be a bit louder than before, could that be ? Also, if I have the valve lash set perfect should the pull cord ever rip out of your...

Hi, Already have stage 1 kit installed on a GPS Tillotson 212. The jet, header & filter really woke this engine up. Going to replace the rod to a billet ARC 6773 and upgrade the cam to a Mod2. Does the flywheel have to be upgraded to a billet type as well? According to the Tillotson spec page...

Hi, Already have stage 1 kit installed on a GPS Tillotson 212. Looking to upgrade the cam to a mod 2, springs and billet rod. Do I need to upgrade to a billet flywheel also? GPS website states the Tillotson 212 has a "lightened flywheel rated at 10,000RPM (not aluminum)" installed . Also, is...

Hi, My son has an offset kart we have been working on together. I noticed the right front slick was low on air. While filling up the tire I noticed that the spindle arm that connects to the tie rod on the right side is really close to the tire compared to the left. It actually scraped the...

Hi, I recently replaced the motor in my sons kart. It had a briggs 5hp and we replaced it with a go power sports tillotson 10hp. Current setup, 11 inch tires, tav2, 15 tooth jackshaft sprocket and 55 tooth rear axle sprocket. Kart plus driver weight around 250lbs. Ran with a 12 tooth torque...

Hi, Was in the process of painting my sons go kart when I noticed the rear bearing on the driven side of the torque converter was completly torn apart. I removed the jackshaft rod and the inner part of the bearing is basically stuck on the shaft. I could hammer it off but I probably will score...

Hi all, I just changed the oil in a briggs 5hp motor. I found the user manual online and it calls for 20 oz of oil. I drained the oil and put 20 oz of new oil in while it was on a level surface. I reinstalled the motor on its 15 degree mount. When I open the oifiller plug, oil is just pouring...

Sorry but a bit of a novice with small motors. Wondering about the key on the carburetor shown in the attachment. Is this just an idle mixture screw? When turned to the left just a little the motor really stumbles. Is the other device just an oil catch can for excess oil. Its connected...

Been reading here for the last week or so. Just picked up an old offset kart with a Briggs 5hp motor. It has 11 tall inch slicks, 15 tooth clutch and a 71 tooth sprocket. It takes a little bit to get going but my son had it clocked from his phone at around 21mph. Seems like there is a little...