Search results

2 comet clutches 3/4 shaft (30 series). Appear to be in good working order other than 1 is missing the inner sprocket/hub thing (refer to pictures). Located in college station Texas but willing to ship. $100 boo shipped, negotiations are to occur in private message not comments. Possibly have...

Any pros or cons with the harbor freight 170 amp 240 volt wire feed mig/flux cored welder? I'm getting into building go karts and vehicle bumpers and have been using a cheap 110 volt wire feed and was looking for a upgrade. Any suggestions? Not looking to spend more than 300-400 dollars.

building a rat rod go kart soon that will hopefully resemble something like these pictures. It is going to be a strictly road kart and I was wondering how low I could go without it being dangerously low to the ground. Want it to be low enough though to keep the rat rod look but not too high. I...

Been thinking about it for a while, finally got most of my parts and went to work. Manco rear end that I found at the junkyard with a bike front end I got from my neighbor. 1.5 inch thick walled square tubing to attach the two. 6.5 predator on the back with a 7.556 gear ratio to some 18 inch...

So i got this yerf dog spiderbox kart with a thunder kart for $275. Both need work. I am building both to resell and make money and hopefully buy a Jeep Wrangler. I was looking at putting a 30 series with a 6.5 HF motor. Do yall think it would be enough power to push the 22's on the rear...

I have a 90cc helix 2003 2stroke atv i need appraisal on. It has forward neutral and reverse. 550 miles on it. Has damage to body plastic. Any ideas on what it's worth? Runs and drives fine.

New paint job. Got a little tired of the old one. Still painting. :roflol:

Looking at tires for my go kart. Want some that will be able to handle mud. Are either of these good? Dont reallly want to break my wallet. Suggestions would be great...

Could this be a problem. Pulled the plug to clean it and saw a little bit of either gunk or rust inside. I havent changed the oil and the motor has only run for about 6 hours. Could this be a problem that needs to be addressed? Thanks! :feedtroll:

Just finnished my kart. 6.5 harbor freight motor. 60 tooth sprocket. Really like the way it looks. Below is a video of it on my channel. https://www.youtube.com/watch?v=mbm3Dfo_o6k

I need a 3/4 inch diameter belt drive clutch and jack shaft. I don't care if it is Chinese off brand or a comet. You would need to ship it to College Station Texas and i will pay for shipping. PM or comment with what you got. Thanks

Hey im a newbie to this forum from texas. I have been rebuilding go karts for 2 years now. I currently have a client that is wanting a deep throaty sound exhaust but wants good compression. Any ideas? This is why I have rigged so far but not deep enough. Thanks guys!