Recent content by tundrabeagle3

  1. tundrabeagle3

    possible 125 for 450 trade ?s

    Hey guys I found a guy on craigs list who might trade his 03 crf450r for my 05 kx125 . It sounds like a good deal but I am a little uneasy about the trade. The reason being that he said he has a new top end on it but says its leaking from the water pump weep hole and the oil drain bolt. I know...
  2. tundrabeagle3

    fast motorized bike

    Hey guys I am selling all my mini bike frames ect, but I have a newish predator 212 that I am going to get running again. I want to put the motor in a beach cruiser bike to ride around the city and race my buddys 5 hp briggs motorized bike. I am debating whether to use a 212 or just buy a 66cc...
  3. tundrabeagle3

    tacoma is squealing in the rear

    I have a 01 tacoma prerunner with 162000 miles that has been making a squealing noise in the rear when I am driving a low speeds. I have searched online and in the manual and have found nothing. I believe it may be the rear bearings but am not sure. I would like an opinion from someone with more...
  4. tundrabeagle3

    need a 22 mm mikuni carb

    Hey guys I need a 22 mm mikuni carb for my pitbike I am looking for a genuine mikuni not a chikuni I live in Corona, CA please pm me with a price thanks
  5. tundrabeagle3

    Comet tav2 30 series

    I have a comet tav2 30 series that is like new it has about 4 hours of use on it and has a rib cut on the back to fit a honda clone. It comes with everything to use it, the back plate , driven , driver, cover, spacers, belt, and mounting harware. I am asking $130 plus shipping.
  6. tundrabeagle3

    mini bike slower with a tav2

    I just tried my mini bike with a comet tav2 and it feels like I lost alot of top end and the motor does not rev up as high anymore. It picks up the front end a little on flat ground, and when going up hill on dirt it easily wheelies. Is there any way to increase my top end to make it rev up to...
  7. tundrabeagle3

    What brakes should i get for my mini bike?

    I have a stretched cat with a tav2 that I need brakes for. It used to have a scrub brake but I removed it due to the excessive tire wear. I built it to hit 50 mph , I bought some chinese 125 quad hydraulic brakes from ebay with plans on mounting it on the rear sprocket. I am having problems with...
  8. tundrabeagle3

    25 to 30 tooth 41 chain sprocket

    I am looking for a 25 to 30 tooth 41 sprocket for a mini bike I have talked to a fellow mini biker before who had one and he said he got it from east LA but did not give me an address does anybody know where in east La I can find a small 41 chain mini bike sprocket? thanks tundrabeagle
  9. tundrabeagle3

    predator 212 hard to start

    My predator 212 is hard to start when it is cold. Every time I start it i need to take out the plug clean it put it back in an pull like crazy. My mods to the engine are a 14 cc head, k&n type air filter, header, and a 90 main jet. It is easy to start when it is hot and runs good . It is just a...
  10. tundrabeagle3

    chain tightening ideas

    I have a stretched cat mini bike that has a 420 chain rubbing on the motor plate. I tried finding a half link but my local motorcycle shop told me they don't make half links for motorcycle chain. I tried moving the motor up but ran out of room. I was going to use a chain tensioner from a...
  11. tundrabeagle3

    Running a predator with no head gasket?

    I have a predator that wasn't starting until i put a little bit of oil in the spark plug hole. It started right right up until the plug got fouled with oil. According to the manual if it starts with oil in the cylinder it is a compression problem. The head gasket has been reused and is losing...
  12. tundrabeagle3

    original cat handlebars and frame trade

    I am looking for handlebars and forks that will fit a cat that are bent forward a little . I have a set of original cat bars that look good but go straight back not leaving me any room for my legs. I am also willing trade my two cat frames for a bigger mini bike frame one is stretched.
  13. tundrabeagle3

    Full throttle lag

    I have a predator 212 that hesitates a little before it begins to accelerate at full throttle. Does this mean that I am running to rich or lean? I cant tell by the spark plug as all my plugs are black from when i lay it down and oil gets into the cylinder.
  14. tundrabeagle3

    Grinding a cam at home

    http://answers.yahoo.com/question/index?qid=20071019000014AA0T8uQ I was hoping to apply this to a predator 212 by sanding the round part of cam maybe .20 on the intake side to get more valve lift. " So when Cam turns around From REDUCED Base Circle Radius,,,and TO the LOBE PEAK,,, The Rocker...
  15. tundrabeagle3

    need 196 cc clone carb and 14cc head

    I need a 196cc clone carb looking to pay 10 for the carb plus shipping. I also need a 14cc head or two looking to pay 20 plus shipping for each. Let me know if you have one and how much you are asking please.
Top