Tu tony's latest activity

  • T
    Tu tony replied to the thread Dune cat bearings.
    I finally found a picture of the original bearing flange locations
    • 6E2C5D47-11B6-443D-AA4D-4DC5E0C04407.jpeg
  • T
    Tu tony replied to the thread Dune cat bearings.
    Bring a trailer auctions had 2 different dune cats for sale with lots of pictures. The flanges were installed differently on each one...
  • T
    Tu tony replied to the thread Dune cat bearings.
    The axles do move side to side a bit. Never did before. Confusing. Hopefully some one will have pictures to save me hours of...
  • T
    Tu tony replied to the thread Dune cat bearings.
    I thought the same so I didn’t take pictures before I disassembled the axle. I do remember cleaning crust strip off the center of the...
    • C979452B-F72B-4C2C-BDB5-96152BE819B6.jpeg
    • DD1189EC-9257-45BC-AD78-D1DD1006FA2F.jpeg
  • T
    I need good pictures of the original bearing (flange) location on the axle. I don’t know if my bearings was installed properly when i...
  • T
    Are the axles supposed to slide out of the differential? Didn’t see any “locking devices”. Mine slid out after I unbolted the bearing...
  • T
    Thanks for keeping an eye out. Just to far to drive the gas cost is about $200. This type of shell was mass produced for amusement parks...
  • T
    Tu tony replied to the thread Greetings from NJ.
    Welcome to the guru go kart forum! Lots of good short cuts for repairs and tips for preventing future problems with using superior...
  • T
    Tu tony replied to the thread Personal Belongings.
    Years ago I had a Frankenstein mini bike. For storage I use a 20”long piece of 4”PC pipe. Glued a cap on the bottom and lightly sanded...
    • 653F99D5-B019-46A2-8A49-3E543D579299.png
  • T
    Can 8” golf cart hub caps fit on Mudhead 208R 8” rims. Can a 3/4” spindle fit as well or do I need to change bearings to work? If...
Top