Recent content by peppy

http://news.yahoo.com/s/ap/odd_bar_stool_dui NEWARK, Ohio – Authorities in Ohio say a man has been charged with drunken driving after crashing his motorized bar stool. Police in Newark, 30 miles east of Columbus, say when they responded to a report of a crash with injuries on March 4, they...

Quick question. I have 7014 rods left over from welding. I am tring to figure out how I should store them correctly. It might be a while before I use them again.

Ok, so I got the Manco put back together and I put on the belt and chain. I start it and it runs somewhat ok. The problem is that when I hit the accelerator, it sounds like the chain wants to snap off and it is jerking when trying to move?? I shut it off and I jack up the rear end and turn...

I need to find its owner..... :bannana:

Found this on the east coast... http://delaware.craigslist.org/mcy/1021056013.html

http://www.tunerlounge.com/forum/showthread.php?t=9

http://www.tunerlounge.com/forum/showthread.php?t=10

I just picked up a Baja Reaction 150cc. I dont know too much about them. Looking for opinions http://www.bajamotorsportsonline.com/product_info.php?cPath=2&products_id=79

or where is a cheap place to get one.

http://www.tunerlounge.com/forum/showthread.php?p=9#post9 I thought it was real at first!

Good enough to weld kart frames? (Kenny is helping me out with it also in the kart section. looking for more opinions)

Ok, So I am going over the frame and realized that the steering is not centered The connecting rod is bent, drivers wheel is toed in and the passenger wheel is toed out and the camber is off. Looks like the previous owner wrecked and decided to bend the rod to make up for the toe in. Anyways...

Hello, I just picked up a manco kart model 485-25 with the 5HP motor. The problem is the sprocket on the shaft is broke! I went ahead and removed the nut and the snap ring but I am not sure how to get the clutch off:confused: Does it just slide off or do I need a gear puller or is it threaded?