Recent content by Mikgokarting

The kart was originally an manco dingo which looked to be modified we restored what we could to get it working whilst we waited for our metal. We rebuilt most of the original kart, engine, brakes, we used a new axle which was given which looked like it was from an manco Dingo aswell for our new...

Engine mods we have fitted: Mikuni VM22 & air filter, no governor, sanded the header and ported and polished it. What upgrades do we do next? the engine has a stock plastic cam unlike the gx200 which is steel cam. Also springs are stock plus the flywheel stock.

At the moment we are running a stock carb and air filter, we want to buy a new carb (not to expensive) my budget is 20/30 for carb and possibly a air filter as we don’t have that for the engine either, should we upgrade the jet aswell to which size cheers Engine is 6.5hp eberth ---------- Post...

This is the go kart after 3 days of fabricating, we have not built one before so it’s not the best but give us your opinions and feedback. We are going to buy an rack and pinion for the steering aswell as new throttle foot pedals for the kart. We are thinking of engine upgrades maybe a mikuni...

The axle is 3/4 and seems to be an old manco dingo axle, the sporcket size is 54, and the clucth is 10 teeth. Just need some help with getting more top speed without reducing the accerlation to much. We have no governor in the engine we taken it apart yesterday fully. We also have no air filter...

There is no governor in the engine, exhaust upgraded, custom throttle setup, aftermarket air filter and adapter plus jet. 54 tooth sprocket and 10 tooth sprocket clutch. Live axle. How can I improve the engine or kart MPH without changing the engine to another one. Do you have to change...

Hey, what speed can an eberth 6.5hp governor taken out, Big exhaust fitted And no air filter with stock carb what speed can it reach ?

Need some advice with an axle that is for our go kart project we don't know what size nuts we need for the axle, we tried 3/4 nlyon nuts but they don't fit, the axle thread has 2 flat sides diameter which measured is 0.733 inches / 18.67mm the rest of the thread diameter measured is 0.750 inches...

Hey, pretty new to this website but I’ve heard it’s great for tips and advice on karts. Me and a few mates have recently brought some 30x30x3 steel hollow square tubing for the kart project. We have cut most the metal to the exact measurements with a bandsaw and are near enough ready for...

Hey everyone I’m new to this website and haven’t had much time to see what’s what but I’ll get straight to what i need some advice on. Me and my mates are planning on building a go kart from steel square hollow tubes im not sure what the best mm tubes are for the project but we know how to weld...