Recent content by Mercado

Are your cams at 108lsa or 104lsa

On the valve seat area we isntall aa bigger seat for valve then ported all the edge and conners and on both sides and on the header im using a F&b custom header its a high center header but with the bigblock size

Im waiting on the 310 cam and i just install today dual springs and it went too 8950 feel very strong

Hi i have the almost the same set up 72x58 14cc head with 32 ans 27 valve 28mm carb cam i have 290lift246 duration with 1.2 ratio rocker i just order a 310 lift and 260 duration for more top end becuase the 290/246 cam was top at 7900rpm becuase it hase 104lsa so the new cam is 260 duration but...

Can the cam limint my rpm or does it suppose to go higher on rpm

Ok i install a 34 timing arc flywheel but now it only goes up to 7800rpm and noe its a 236cc ita 72x58 with the ec 236 crank kit what could be my problem

I just saw the new billet side cover has a bearing for the cam vs the Arc billet cover that dont have the extra bearing for the cam what would that help in ok the cam faster spining or noy really any advantage over the Arc

Hi guys any one have experience with the +.080clone crank shaft on a hemi bloke and from what clone did the crank come from ...any help would be great thanks

Can any of the experience guys tell me if the predator block can be bored .80 and still be used for track racing or will it not hold to much heat at the race

Can any body talk to me about the mod 2 cam on nr 1.2 rollers i know the cam pulls to 7000 but my question is from what rpm does it start pulling good drom 2k to 7k or from 4k to 7k ---------- Post added at 10:39 PM ---------- Previous post was at 10:38 PM ---------- And compare to a cl1i cam...

Hi guys im new here i have a hemi with 18lbs springs and a cl1-i cam milled .30 head and .10 head gasket what rollee rockers can i used with the set up 1.2 or 1.3 and what would be the advantage over stock

Well im about to get a billet flywheel for my hemi what can i spect with it gains up top or better on the botton to midrange i would like to hear reviews from any one who has one on a minibike

I guys im new here and i have a hemi 212cc just install a cl1i cam and i notice i lost a little low end power install a #8 key on it could that key be less like a #7 soo i could get a better low end power