Recent content by Lugnut

  1. L

    2021 - LUGNUT’S 212P Bike “Psycho Billy Cadillac”

    Finally I don’t have to plan so far ahead… ordered hydraulic brake setup from Go Power Sports… machined a caliper bracket from a chunk of 1/2” 6061 aluminum plate. Had to flip the banjo bolt & redirect the line to use it. It clamps on a 203mm Avid 6-bolt rotor. It’s a bit thin for this...
  2. L

    2021 - LUGNUT’S 212P Bike “Psycho Billy Cadillac”

    Here’s a couple pics showing the aluminum rails for the motor mount. The 1st & 3rd pics show the pedal sprocket & rollers. I milled pockets in the underside of the 1/2” motor mount plate to accommodate the 3/8” grade 8 bolt heads that fasten the aluminum angle that carries the rollers to the...
  3. L

    2021 - LUGNUT’S 212P Bike “Psycho Billy Cadillac”

    Here’s a view of the pillow block. Found a little chrome cap that just happened to fit, covering the bearings.
  4. L

    2021 - LUGNUT’S 212P Bike “Psycho Billy Cadillac”

    Plate from torque converter that was eliminated and pillow block that replaced it. It’s solid.
  5. L

    2021 - LUGNUT’S 212P Bike “Psycho Billy Cadillac”

    New here... thought some may enjoy this one. Not quite finished. I’ll post a few more pics along with explanations as soon as I have time. Thank you all for reading and allowing me to be here! So I started out with a Micargi frame and a predator 212 hemi. I was going to install the motor...
Top