Recent content by GreyW00lf

  1. GreyW00lf

    Is it possible to put longer Leads and fluxcore lines on a 110volt welder?

    thanks i'll stick to what i have then in that case.
  2. GreyW00lf

    Is it possible to put longer Leads and fluxcore lines on a 110volt welder?

    Is it possible to put longer Leads and flux core lines on a 110volt welder? right now I have about 8 feet or maybe less on my leads and fluxcore line combined. I'd like to not have to move the Welder around as much so I figured to make both my flux core and clamp lines about 10 feet long on...
  3. GreyW00lf

    Wolfs Grand Daddy Build/log

    it's another 4 or so feet bigger in length and about the same in height
  4. GreyW00lf

    Wolfs Grand Daddy Build/log

    Nothing I can do as it's an rental, plus the electrical panel is So Overloaded From bad wiring jobs (D.I.Y. Electrical person/s) from before I moved in. And no room on the panel to install another breaker/run just for one thing
  5. GreyW00lf

    Wolfs Grand Daddy Build/log

    The weld didn't break, yes it is a 11o volt welder. I'd turn it up however any higher on the voltage/speed it pops the fuse on my breaker.
  6. GreyW00lf

    Wolfs Grand Daddy Build/log

    mine was noonish/midday... so i figured it wouldn't bother anyone...
  7. GreyW00lf

    Wolfs Grand Daddy Build/log

    Lol I have done that already, had the cops called because of it. Neighbor was scared that I was beating someone to death with the 5 foot long pole I made. the Cops laughed when I told them that I was just testing my welds on a rock, metal just bent but the welds held just fine. the Metal is .100...
  8. GreyW00lf

    Wolfs Grand Daddy Build/log

    Hello All. Just started yesterday of my own build of Spidercart's Granddaddy Go kart. Some of my welds do not look deep or right to me, so I've Included a pic of my welder's settings nobs for you guys to help me out a bit. My metal guage is .100 which I believe is roughly a bit too thick but...
  9. GreyW00lf

    Quiestion on if i should lengthen my grand daddy go kart?

    ah thanks all. so 6 inches would be batter then 4... i'll keep a build log shortly
  10. GreyW00lf

    Quiestion on if i should lengthen my grand daddy go kart?

    Question on if I should lengthen my grand daddy go kart? By say 4 inches length I'm looking over the Plans I have and seeing as I'm 6 foot 2 inches tall, I figure to make changes to the plans to somewhat be more comfortable for me.
  11. GreyW00lf

    Hows my Welds?

    Thanks all for your Advice, I will post another pic when I get the chance.
  12. GreyW00lf

    Hows my Welds?

    it does make sense to me, I have been practicing slowing down and doing little loops but it is not easy and it is Flux Core.
  13. GreyW00lf

    Hows my Welds?

    Hello All, Just wanted to show you guys my welds so far as I am learning to weld, Any tips or trick you could give me would be welcome.
  14. GreyW00lf

    Advice - Spider Carts Grand Daddy?

    I too have the Grand Daddy plans from spidercarts.com, Have not yet started to Build it as I'm waiting on the annual spring thaw for my area, plus having to build a workshop of sorts to build in
Top