Recent content by EagleTalons

Hello I have an older motorcycle caliper for sale. When I find the bill that says what it is I'll post that too. I don't want to throw it out as it still works. All you need to pay is shipping. Which will be around $10.

I recently purchased this caliper. I was wondering, what size of disc would it take and what size of master cylinder to run it? http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=250616213277&viewitem=&sspagename=STRK%3AMEWNX%3AIT

I want to buy a 1" hub 60 tooth #35 sprocket please.

Hello, I have a Coleman Generator that has a leaky carb and needs a few oil seals changed. I was wondering where do I get parts for these engines? They seem to have the Coleman brand on them. I do have a serial number off of the sidecover. KF82D 1010325

WTB 1" Axle Hello I am wanting to buy a 1" Axle it only has to be 20". Its for a minibike. Thank you!

Hello, I was wondering where I could find something that would work as a wheel bushing. Its needs to be 1" ID and 1 3/8" OD.

I'm currently having troubles fixing a set of ATV brakes. They are on a Rancher 350. Its the front hydraulic drum brakes. I'm thinking its the master cylinder because barely any fluid comes out of the assembly. Even when connected to fresh line. I also want to know. What exactly does the...

So I finally got around to ordering a helmet. I decided to go with a full head one with a face shield after reading posts. Its dot approved and was only...$11. I love Ebay! It is new also! Here is a few pics with my head stuff into it. I need to adjust the padding still for my dumbo ears...

I was wondering where I could find a helmet that is reasonably priced. I want it to look like this guys helmet, so I can wear glasses or goggles.

Well, I'd better start at the beginning. I reused the old piston and rings. They were marked 6...or 9. It was running fine until I noticed that the side cover gasket was leaking. So, I took off the engine and got the cover off. The gasket hadn't sealed. I decided that since I was in here, I was...

I am currently trying to make a push in muffler. I've saw some on VW's with stinger pipes, but never on anything else. I have a 2 staged header. I'm not quite sure what would make a nice sportscar sound though. What materials should I use? How many holes should be drilled? Kinda not sure.

I finally ran my engine and I had the 160 jet in the carb for a main jet. It was obviously too lean, as it would bog severely at the upper half of the slide. I put in the 190 jet and its a bit too rich as I fouled a plug...:oops: What jets are you guys running on your engines? I have a 5hp...

I have some mini bike goods that I would like to sell. Hillard Extreme Duty Clutch, rated to take 13hp. Never been used on a kart, only been placed on engine. Max Torque SS Clutch, normal clutch. MiniBike Chain Guard and Mounting Plate. Keeps feet out of chain MiniBike 10" tires...

Well I finished my briggs...kinda. When I tested my engine the exhaust had both suction and exhaust... The intake only had a a small amount of suction. So I looked at my crank and cam and saw the dots were off, I aligned it with the 2nd tooth left of the casting. So I took it apart last night...

I have a Mikuni 22VM that needs parts number 7 and 1, but I don't know where to find parts for these at... http://www.mikuni.com/pdf/vmmanual.pdf This is the parts guide I used.