Recent content by DangerSeeker

Put the heat to it and it scooted over with a few bangs of the ball peen!

Still bangin on it Well, after days and days of spraying and tapping on this dang sprocket, i've decided to take the whole axle off, put it in a vice and see if I can coax it sideways with a bigger hammer!

All the set screws are removed and I'm shooting wd40 on it every time I go out to the garage. I'm gonna let a soak for a few days like this and then see what I can convince it to do using a hammer. Let ya know how it turns out.

It does look a bit rusted, thats why I was thinking maybe soaking it for few days in some penetrating oil and going after it again with a hammer.

Hey guys, I'm sitting here looking at the sprockets on the dog and the large sprocket on the main axle is offset from the 9 tooth on the jackshaft? (i think it's called a jackshaft...could be wrong!) by about 3/8" . It looks like theres a keyway in the large sprocket and also set screws to...

Hey Mike, Great video series. I'll definitely use it in the near future.

Mods When I take the gov off, is there anything to be aware of? Like springs that are attached to it, etc.? I was also wondering about the low oil sensor...I disconnected the wire at the quick connector located inside the little black box adjacent to the shutoff switch. Will this take care...

I'm right there with you man! I wish I had put one of these bad dudes on my boys little Streaker when we first got it 4 years ago! Hey Mike, can you give me some pointers for some simple mods that won't compromise engine life, etc.? Inexpensive is also good!:)

Hey guys, I recently removed the pulsa jet carb from my little briggs motor and I lost the mixing spiral !! Can anyone direct me to a source for this part? Or to someone that might have one for sale? Or a complete carb? Any help would be greatly appreciated. :D

I looked and looked before I posted this question and I'll be danged if I didn't run across a similar discussion about 2 minutes after I posted it! I'm with you Mike...I'm gonna pull the motor off the streaker and see how much too short it actually is and then figure out something with a spacer...

Hello, I just bought a 3203 today and I'm going to have to put an engine on it. I just put an HF 6.5 on my little streaker and want to use one on the 3203. The guy I got it from said he tried to do that and the crank ended up being too short and the pulleys for the torque converter wouldn't...

I just joined the site and I'm really excited about getting our latest family project up and going. I really appreciate any advice you folks can provide. Thanks and see you in the forums.