I contacted kaszumausa they don't make the hubs anymore. maybe i'll find some bearings to fit the ATV hubs and this 15mm spindle.
for now maybe i'll just use lots of Loctite to hold the nut on.
Is there another brand which makes the same model.
Someone changed a few parts and now I can't find OEM parts.
the front hubs are gone the ones I found on amazon and ebay are close but too long and I can only get the nut a few turns. With some lock tight it will work for now but I would like...
I found these two engines for sale for a good price.
MY 196cc smokes. has gotten better but one of the exhaust studs stripped so I was looking at my options rebuild, or see whats out there.
I am assuming the 390 is what the predator 420cc is cloned after?
why are the clones bigger but the same...
I have had 2 carbs on this motor 196cc. both would run best closed choke
I can open them up but doesn't seem to make a difference.
if i open it up all the way it will stall out.
I'm used to it now and
this is how my son has learned to shut off the go-cart.
I have 145 / 70-6 front and 16x8-7 rears
my rear rims from what i can tell have 19 splines.
I have not found rims that will fit. I have seen hubs but no rims.
Would would be the best route
I want bigger wheels for more ground clearance. I have been searching different tire sizes. I can't...
I got the cart running and driving and by god stopping.
I was looking at a hammerhead torpedo on facebook
its ride height seems so much higher than mine.
they are very close in build
it could be my shock are just old. I then thought what about bigger wheels especially in the back.
I have 6...
I'm nearing the end of my project and I get the engine running
and its ****ing oil out the exhaust.
I'm so close to driving this thing I can taste it.
I don't have the tool to test compression.
Pulled the head and oil was sitting in the cyl.
no damage to the walls
did an oil change...
I have a AMW hornet 3170
I see 2 different part numbers listed. on the parts sheet
this caliper looks like many others i figured they would be readily available. but not sure which one and the cost is different from
gokartsrus.com no one has specs.
14658 LF OR SGL CALIPER 150CC, 250CC...
I picked up a hisun 196cc. (i was told it was a predator but its not)
I can't get a predator for some time until they get restocked.
But I need something the make the engine brackets.
with that said
Is there enough parts for this engine? its for my kids so i'm not worried for now about making...
I picked up a hornet frame. cheap.
The only thing is it has no engine. I planned on putting a predator 212
as this seems very common. but i noticed this kart has a raised mounting plate which i do not have. i can buy a new one but thats for an engine i plan on not using. I can't find much on...