Recent content by Butterland

Texas here, looks nice if it was close I’d buy

I haven’t done much regarding a sprocket yet; trying to get engine running first. So I pulled the car off, cleaned it, fixed the throttle adjustment so it can be adjusted, it was stuck in place from a bend-looked like a rock fell on it. Anyway the carb appears clean, throttle and choke can be...

I’ll measure the driveshaft today. After I took the belt drive part off I thought it looked good cause it wasn’t tapered; I didn’t measure thoyg

I didn’t see that, where do I find it? I’m in Texas, near Dallas. A friend of mines husband has an old non running gokart frame, with and engine not sure if engine works. she is trying to get her husband to be ok letting it t🪙go.

Yes it was free. Here’s a pic, it had a belt drive attached

That first pic is from the actual tiller

These are pics of the engine. These are directly from the engine. I’m having issues finding where to get the right parts. I wanted to start with spark plug and then move to carburetor. I was hoping someone here might be able to help

Yea I’ve been searching for a metal frame, already welded. So far I have not found the frame, the search continues. I did get a 4hp Briggs and Stratton engine on a tiller. It doesn’t start at the moment. Hopefully it’s just a spark plug. But as I’m looking for the frame I’ll try to figure the...

Sorry that’s the arc welder...

And the reason I’m aiming cheap is because Im a nurse with 5 kids. Between the motor and wheels I thought I was doing good, the frame pieces I had around the garage. And I didn’t expect much from the motor, so I thought the kids could use it. If I got square metal bars and bolted them would...

I appreciate your answers. I wasn’t asking to challenge your answer. I took the front off, and would plan on putting two wheels up front. The motor I had on it didn’t shake it, so I consider the shaking, granted it didn’t drive. Looking in those sites si far I found karts and a few frames...

Ok, I’ll see if I can get a pic of the frame, I haven’t seen it, my wife just heard about it. And I’ll see if the pressure washer: 3/4” horizontal shaft that is not tapered If the engine is bad I will just wait for the next sale on the predator 212. And I’ll spend the time till then making...

Dang you don’t even think the back end is good? Like those last pictures? Metal pipe and 2x4.

I do appreciate all the advice. I have no one around me with knowledge of this type of stuff and out of my friends I'm the only one into garage projects, and building stuff. The reason I wanted a wood frame is I have always been more competent with wood, and I don't have a welder. Looks like...