Recent content by BriggsTwins

Hey ya'll I'm looking to get some off-the-top prices for this guy, I got it from a friend and with the current situation I will most likely NEVER put it to use, sucks to see it go, but that is LIFE! :roflol: So, the run-down, 1. 150 stick welder/genset portable 2. replaced bridge rectifier...

Easy as 1,2,3 right? Well, to kick it off, here are some pix of what I have on hand, there are a few more goodies, but ill just give ya the interesting parts! If you notice i have a gas welder/generator, does anyone want this? chances are, i will not be able to load and transport it simply...

Corny intro's aside, after a long hiatus I am finally getting my rump back into gear in building and such. on the list so-far i have 3 engines 1. My briggs opposed twin :) -40$ 2. honda trx200 shaft driven with rear end. free 3. some china scooter with a cvt (pending) free I want to very...

Hey guys i have been cleaning and found a brand new backplate for the tav2 30 series kits. it does not have the drive or driven pulleys and the cover, but it does have the shaft. If you guys are interested post up an offer. look ill take anything over 20 with shipping combined. Let me know!

hey fellas im building a tachometer using an analog meter, problem is i need to know the average voltage or frequency coming off the magneto, i also have a magnet sensor that i will be making a different circuit if i cannot take off of the mag Bob :roflol:

Hey guys i found a jeep 3 speed tranny that im gonna use for a kart, it will be more than enough and so will my twin but i have a problem. I need an axle out of some car, it MUST be small, like the rear diff out of a subaru or otherwise.. any tips?

http://www.youtube.com/watch?v=dSPDigi9owo&feature=related need i say more?

I am currently working on a go-kart, for the snow, the idea is based from the video i have included http://www.youtube.com/watch?v=b-cWxqwpQqA I have a dynamark tractor with a 5 spd peerless, i have now victimized it for the front end (steering) and the trans/tensioner parts, pix will come...

http://www.youtube.com/watch?v=pbm0CKmiD3Y cant be simpler post yours up, show some snow and burn some fuel

Well the monster has developed a rather daunting problem, the valves on jug 1 are sticky, not seized just sticking! while it runs you can hear the valve rap. i did snap them a couple times to free them up but to no avail. any ideas or solutions you may have? not truly worried about it but i...

the old manco is finally out of storage, it has a 6 horse i/c briggs and a tav2... it wont soon...

Hey guys, just happened to get my hands on a 90amp welder from harbor fright, its got alot of kick to it. very impressed, did a weld test and it passed, ugly but it passed

http://pittsburgh.craigslist.org/rvs/1507706347.html take a look, i recall a convo about these things. Ad isnt mine, but figured DIY would enjoy taking a look

Hey guys found an OLD engine in the shed, its a honda 125 missing an assortment of pieces. i cant recall the year on it but it does have compression and the valve train is intact, But there isnt a carb, oil plug, CDI coil, or some covers for it. what do ya think?

Well guys it was fun to sit and play for a while but im side lining the kart and everything for now. i dont want to but i simply cannot do it. loved hanging around and reading about it but now its getting to me so im off, im leaving too! hopefully ill be back with news and a monster to prove it...