Thanks again for your reply.
I have the compression fitting like the one you listed first but couldn’t get to seal I guess there should be an olive and insert or something.
In the end I found this which should be ok to screw into master cylinder and has the speed fit connection or self sealing...
Make sure your tank breather isn’t blocked too if it creates a vacuum it won’t allow fuel to flow after a few minutes especially if tank is full to start with.
Basically I need a way to make 6mm brake cable fit the connection that’s shown in pic labelled other.
I’m assuming there is an olive and insert but can’t find.
I’m happy to replace for a straight connector or elbow like the one shown in the first pic but can’t find that either.
hi there people can someone please point me in right direction before i go mad, how do i connect to the non speedy fitting brake line, my cylinder has those lovely tappered push fittings (like stright one below which would be perfect i could just replace master cylinder with this accept this one...
Hi there I’m hoping some one can give me some pointers, I have been doing up an old kart with my son over the lock down, we have only been messing about with it just nice to have a project together, I took out the old jack shaft and replaced with a torque converter added a few bits like...