DIY Go Karts

ApocGoD · #1 10-02-2009, 12:31 PM

I have a techumseh transaxle, how do I figure out what model it is?

Kaptain Krunch · #2 10-02-2009, 01:14 PM

Should have a little shiny ID tag on it somewhere, normally on the side or front. Take a picture of the transaxle and i could possible tell you what it is/where the tag is.

ApocGoD · #3 10-02-2009, 01:23 PM

Roger that, will try to soon. I looked all over it and didnt see a tag though, might be buried under dirt. Haha

ApocGoD · #4 10-02-2009, 02:24 PM

Still not seeing a tag anywhere, cant find a camera to post a pic either. Any ideas?

porsche930dude · #5 10-02-2009, 07:57 PM

why does it matter?

freakboy · #6 10-02-2009, 08:03 PM

there any numbes on the top? what kinda config is the thing is it a transmision? or transaxle. what are the sizes of the shafts comin out for the wheels comin out? whats the input shaft dia how many gears what pattern.

ApocGoD · #7 10-10-2009, 12:18 PM

Ive looked all over it. No numbers. Small shaft, maybe 1/2. righ to left gear config.
54321NR on top of the trans. Not sure if its a transmission or transaxle. The shaft runs through it. Its on a very old Weedeater mower from sears.

ApocGoD · #8 10-10-2009, 12:19 PM

Coming out to the wheels is 3/4 I believe.

Kaptain Krunch · #9 10-10-2009, 01:17 PM

Probably either an 800, 900, 920 or 930 series. Take a picture.

ApocGoD · #10 10-12-2009, 08:08 AM

I found the model number. 205544c1017b0489 is what it says, and Peerless above it. Any ideas?

ApocGoD · #11 10-13-2009, 02:45 PM

The model number is 205 544c 1017b 0489, any idea what that means?

freakboy · #12 10-13-2009, 03:37 PM

there should be a little silver tag goin around were the case splits.

ApocGoD · #13 10-13-2009, 03:38 PM

That was what the tag said. Peerless and the model number

freakboy · #14 10-13-2009, 03:47 PM

i got no freaking idea mabey a 204? i dont think it exists. lol pictures?

mike75925 · #15 10-13-2009, 04:03 PM

trying to find it. is it a separate part from the rearend or is it a rear w/ tranny?

ApocGoD · #16 10-13-2009, 04:07 PM

The shaft runs straight through it, its part of the tranny.

mike75925 · #17 10-13-2009, 04:23 PM

so a transaxle, ok. they do have just trannies. try 3 speed with reverse thread, you can see some units that are just trannies

ApocGoD · #18 10-13-2009, 04:24 PM

I have this one, its on my mower, im just trying to figure out what it is to see if its worth keeping.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

The Following User Says Thank You to Kaptain Krunch For This Useful Post:
ApocGoD (10-02-2009)