|
#1
08-07-2009, 12:05 PM
|
|||
|
|||
Help!!!
Ok, so I bought a mini chopper(see my post in that area) and the briggs 5hp I also bought has a tank on it. I want to run the tank from my chopper, but the way the carb is set up on the briggs, I cant. I went on ebay and bought a walbro carb for a 5hp, and not knowing much, when it got here, it didnt have a throttle spring. I took it in to the local hardware store, and come to find out, its a briggs 5hp VERTICAL carb, and I have a horizontal motor. More to add, it only has one setting, full open. I was wondering if anyone has jerryrigged one of these, I will post a pic of what I am thinking of doing a little later.
|
|
#2
08-07-2009, 12:22 PM
|
|||
|
|||
|
here is that pic, it will be a flange into the carb, and the two posts sticking out will probably just get plugged, the carb will be gravity fed.
|
|
#3
08-07-2009, 12:36 PM
|
||||
|
||||
|
ahhhhh i have a idea sell it on ebay and get yourself a minikuni i dont think i spelled it right.
__________________
Pardon me, sir gangster! but it apears your pants are declining in elevation!
|
|
#4
08-07-2009, 12:38 PM
|
|||
|
|||
|
I dont think I can get more for it than I payed, but I did get a good deal.
|
|
#5
08-07-2009, 12:41 PM
|
|||
|
|||
|
get a minikuni cheap on ebay just look around and it'll be worth it
__________________
"No one is going to open doors for you your whole life, sometimes you have to open the dor yourself." Eddy
|
|
#6
08-07-2009, 01:21 PM
|
|||
|
|||
|
I cant find one on ebay
|
|
#8
08-07-2009, 02:04 PM
|
|||
|
|||
|
whats that?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
