Go Back   DIY Go Kart Forum > Building Plans And Advice > Engines & Clutches


Closed Thread
Thread Tools Display Modes
Old 05-30-2010, 10:59 PM
whaleit's Avatar
whaleit whaleit is offline
Join Date: Dec 2009
Location: Tarpon Springs, Florida
Posts: 35
Thanks: 16
Thanked 1 Time in 1 Post
Default Throttle Assembly Pics-for Jemo

Shown on Harbor Freight Engine.

The KIT purchased from AGK worked...but as posted in Dec 2009...."The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as should and actually allows the idle screw to do its job."

It came too long and by not allowing the throttle to close it was always reving too high.

Jemo....hope that your problem is similar and you get it fixed...good luck!
Attached Thumbnails
Throt_001.JPG   Throt_002.JPG  

Throt_003.jpg   Throt_004.jpg  

>>>first timer fixing old frame and mounting new blue honda clone...no need for speed here...yet
Closed Thread

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -6. The time now is 03:20 AM.