Go Back   DIY Go Kart Forum > Building Plans And Advice > Engines & Clutches

Notices

Reply
 
Thread Tools Display Modes
  #21  
Old 10-17-2019, 06:46 PM
turnleftandgasit turnleftandgasit is offline
Member
 
Join Date: Sep 2019
Posts: 30
Thanks: 0
Thanked 1 Time in 1 Post
Default

New TQ did the trick. 41 mph. I need to make spacers for the jack shaft as the lock collars will not hold it in place. I will also be getting a bigger rear sprocket. It pulls the 54 just fine but will be more fun with a 64.
Going to MO tomorrow to pick up a blown up GX 390. Low hr rod failure. This will give me the small port head along with the flywheel and the newer CDI ignition. These coils have a 4500 rpm rev limiter built into them. Gonna roll the dice and see how long the stock rod lasts at that rpm as I will be disabling the governor.

Block will be put away to await a 92mm bore and a balanced stroker crank. 440 cc
Reply With Quote
The Following User Says Thank You to turnleftandgasit For This Useful Post:
landuse (10-18-2019)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -6. The time now is 10:06 AM.