View Single Post
  #6  
Old 07-19-2019, 02:09 AM
Mrmonk7663 Mrmonk7663 is offline
Senior Member
 
Join Date: May 2019
Location: Houston, Texas
Posts: 456
Thanks: 113
Thanked 83 Times in 67 Posts
Default

Got the suspension tightened up and the wheels on the front. The seat frame came back from powdercoating and I mounted that too. The seat I had ordered was the same Inised on the 3203. I thought it would fit the 30032 but it is quite a bit different. I separated the top and bottom. I pulled up some staples and cut some of the seat base off as it was too wide. I relocated the T-nut. Reattached the vinyl with fresh staples and bolted it down. For the back seat I cut out a seat board tonight and am in the process of making it. Project is coming along nicely overall.
Attached Thumbnails
838A6B04-0074-4176-825E-DC7015D7FC0F.jpg