View Single Post
Old 11-15-2012, 02:43 PM
Amped's Avatar
Amped Amped is offline
Senior Member
Join Date: Nov 2012
Location: Port St Joe, Florida , U.S.A.
Posts: 180
Thanks: 4
Thanked 6 Times in 6 Posts

You use some terms that i don't follow clearly. Would you explain a few for us un-informed folks. When you say floor, throat , seat , bowl which areas does that refer to? I'm very interested in learing some basic machining for building my on small engines. I find them all the time that people throw away because they dont know any better so extra heads to practice on are not a problem . You also mentioned cutting a head up. Do you do this to allow you to examine which areas would be best to work? What are basic areas to look at?
Answers are useless without the question.