View Single Post
  #51  
Old 10-10-2012, 02:41 AM
AMMFAB AMMFAB is offline
Member
 
Join Date: Sep 2011
Location: Phoenix, AZ
Posts: 57
Thanks: 1
Thanked 35 Times in 11 Posts
Default

I blended the throats to seats but did not do any material removal to the bowls only cartridge rolled them. until I can get a spare head to cut up I'm not going to do anything extreme. I could always get the welder out and raise the floors a bit so it's not a straight shot and then a 90 degree turn into the cylinders but that will cost some $$$ For the person that wants that..... believe me I've thought about it. I've done to some ford cobra jet heads..... What a pita that was.