View Single Post
  #43  
Old 10-02-2012, 07:27 PM
AMMFAB AMMFAB is offline
Member
 
Join Date: Sep 2011
Location: Phoenix, AZ
Posts: 57
Thanks: 1
Thanked 35 Times in 11 Posts
Default

Quote:
Originally Posted by oscaryu1 View Post
Careful dropping the port floor so far.. I can see this head only on a relatively high revver.
i rarely lower the floors on any given head. i lowered the floors on the inlet of the intake port and the outlet of the exhaust port on the clone head just enough to even them out and no more. i can only assume u say u would see this on a high revver because it looks as though hogged the ports out but theres a taper effect going on sir. funny thing is that engine will see north of 8k though.


mike