View Single Post
Old 01-20-2020, 06:31 PM
Stew Stew is offline
Join Date: Dec 2019
Posts: 40
Thanks: 7
Thanked 17 Times in 13 Posts

I got the cross pieces mocked up for the motor mount.

When test positioning the motor my clever idea of going up and over the sprocket was going to get in the way of the chain no matter where I positioned the motor plate. I tried laying that front cross member down so it would go around the back side of the sprocket but it still interfered.

While staring at it I came up with an even better way to mount that motor plate where I want it and keep the sprocket and brake disc between the frame rails, I almost got the new design finished but ran out of daylight. I'm starting my work week so it might be a few days before I make more progress.
Reply With Quote
The Following User Says Thank You to Stew For This Useful Post:
landuse (01-21-2020)