View Single Post
  #1  
Old 05-02-2019, 04:47 PM
Ted83 Ted83 is offline
Junior Member
 
Join Date: May 2019
Posts: 5
Thanks: 0
Thanked 0 Times in 0 Posts
Default Gx160 crankshaft length?

Hi, just trying to fut a torque convertor to a gx160 but it seems as if the 3/4 shaft from the engine is too short. There is about 1 inch from the outer face to the end of the crankshaft output.
Is this normal or is there different length crankshaft's?
Thanks in advance.