View Single Post
Old 09-17-2009, 07:04 PM
frederic frederic is offline
The Junk Man
Join Date: Jun 2009
Location: New Jersey
Posts: 385
Thanks: 7
Thanked 43 Times in 37 Posts

In order to determine the appropriate length of the rear a-arms, I needed to assemble the rear spindles fully, but not before I machine a pocket for the upper and lower a-arms to go into. So, that's what these pictures are of... machining the pockets.

I imagine some of this gets boring to look at after a while however some of you did ask for machining pictures, so I'll continue to post the nitty gritty details as things progress.
Attached Thumbnails
elec-truck-194.JPG   elec-truck-195.JPG