View Single Post
  #107  
Old 09-14-2009, 03:28 PM
frederic frederic is offline
The Junk Man
 
Join Date: Jun 2009
Location: New Jersey
Posts: 385
Thanks: 7
Thanked 43 Times in 37 Posts
Default

Back to welding.

Pic 1, 2, 3 - the start of the "bends" of the backbone that will go around the differential. Obviously I cannot go *through* the differential ;-)

Pic 4: The backbone is essentially complete as now I have the rear a-arm mounts drilled, machined and welded on. The next step is my most hated part of any metal project - grinding off slag and mig balls.

I also started machining the bushings for the rear a-arms (upper and lower) and I'm assuming since they're almost identical to the front bushings you probably don't want another 20 pictures of my lathe spinning away. I figure I'll save the space on this forum system.
Attached Thumbnails
elec-truck-185.JPG   elec-truck-187.JPG  

elec-truck-188.JPG   elec-truck-191.JPG