View Single Post
  #8  
Old 02-19-2020, 07:34 PM
karl karl is offline
Senior Member
 
Join Date: Feb 2011
Location: North east Ohio
Posts: 1,570
Thanks: 126
Thanked 338 Times in 273 Posts
Default

Quote:
Originally Posted by Budget GoKart View Post
So heres a thread to blab about your one wheel peel karts.
Ok, Im putting together a motor or two (well, technically 3 lol )

But I want to see how much rubber a (single?) small block can peel on the 1wd machine

And I get bored lol

I included a pic of the stock rod that has seen slight oil starvation from excessive speed, 7k + , not much longer for this world. I replaced the crank and rod, no worries. This was the motor that blew the flywheel magnet , fun times

So I guess you can call it a hemi predator, but the only parts left from harbor freight are the block, flat top piston, rings, and wristpin.

BSP forged crank, 55mm stroke
BSP performance T6 rod
Nr racing 252 rattlesnake cam, 230 duration
22lb springs
Chrome Moly Push rods
Maybe champion or roller rockers?
Genuine GX200 head, milled .050, ported, lapped to block no gasket, running 12.7 to 1 compression, probably cam2 leaded will be fuel of choice
Genuine honda GCV190 coil and flywheel
26? mm slide carb, port matched straight pipe
Shroud, recoil, ect from GX160

Just a budget build

I think she should approach 20hp, so it should peel good
Attached Thumbnails
20200219_205908.jpg   20200219_210101.jpg  

20200219_211308.jpg  
Reply With Quote