View Single Post
  #10  
Old 07-29-2018, 03:38 PM
420Power 420Power is offline
Junior Member
 
Join Date: Jul 2018
Posts: 9
Thanks: 0
Thanked 2 Times in 2 Posts
Default

Yesterday, we took the Kart over to a buddy of my dad's, that has a hydraulic ram and a MIG. The roll cage was slightly bent in the front end and rear end (presumably from a previous roll over or accident), so it needed to be straightened out, while it was getting straightened out, some more support for the roll cage was welded in so it wouldn't bend up again (in case of a roll over), the person who designed the roll cage, clearly didn't know much about building cages, because there was no support anywhere... The guy who reinforced it has built many cages in cars in the past, and I can already tell how much sturdier it is.

Sent from my SM-G935P using Tapatalk
The Following User Says Thank You to 420Power For This Useful Post:
ezcome-ezgo (07-30-2018)