View Single Post
  #20  
Old 05-29-2015, 11:51 PM
slidewayz's Avatar
slidewayz slidewayz is offline
Senior Member
 
Join Date: Feb 2015
Location: USA
Posts: 119
Thanks: 40
Thanked 51 Times in 37 Posts
Default

Update:
Well I changed my mind on a few things.
I am going to build 2 chassis, one out of the original planned .063" and one out of a much heavier .090", just to see how much difference there is between the two.
The above photo is the 090 routed out and I have those pieces home now and have reset my brake and am beginning to start the bending and forming process. I have one side rail bent so far and boy is it stout.
I have also routed the bumper side plates for the front and rear, and also made a small plate that will bridge the steering column support and the center bulkhead, for a bit of personalization.....


Thanks for the comments guys!!!!

I just need to raise enough bucks now to make my order to Azusa.

PS, for those that dont know, I am making aluminum old style number panels and some vintage karting decals.
Here is the Nassau Panel, they are 50 bucks shipped to the lower 48 states only.



Thanks again
__________________
http://www.diygokarts.com/vb/showthread.php?t=29484