Thread: 2016 - Arachnid
View Single Post
  #24  
Old 04-26-2015, 03:10 PM
alexV alexV is offline
Member
 
Join Date: Dec 2014
Location: Romania
Posts: 89
Thanks: 20
Thanked 3 Times in 3 Posts
Default

Getting better at welding, but still have to grind and redo some of them.
Almost no jig was used for this part. Just by following the tips mentioned earlier (weld order: outside edge, inside edge, then sides) gives good results and no bending.

Cutting the compound angles for the side-rails was interesting: three engineers debating: cut this way, no that way, no, flip and then like this