View Single Post
  #6  
Old 02-12-2019, 05:44 PM
MacGyvers Workshop MacGyvers Workshop is offline
MacGyver
 
Join Date: Feb 2019
Location: Portland, TN
Posts: 55
Thanks: 5
Thanked 18 Times in 15 Posts
Default #6 The chain tensioner

I used my bandsaw to make nice even cuts, then drilled the 2 parts together to make sure they are perfectly matched. There is an angle bracket that the axle bearing will mount to, and thick reinforcing plate that will go underneath the slider assembly. It is all locked together with 1/2" grade 8 bolts. Then you can see the finished product. There will be 3 of them, and they can draw the axle back nice and evenly (I will check it with a tape measure using the front axle as a guide).
Attached Thumbnails
IMG_20190106_180232.jpg   IMG_20190106_182523.jpg  

IMG_20190106_183553.jpg   IMG_20190106_193611.jpg  

IMG_20190106_193624.jpg  
Reply With Quote