View Single Post
Old 02-06-2017, 10:43 PM
pRoFiT's Avatar
pRoFiT pRoFiT is offline
Can't buy it?, build it!
Join Date: May 2016
Location: California
Posts: 1,039
Thanks: 160
Thanked 265 Times in 220 Posts

This project really calls for a lathe

Need to resize this pipe down a couple thousands so my bearings will fit!

drill, ducttape and start with 80 grit and work my way up. Cleaned up the pipe but still need a little more sanding. This pipe is 1.5" od and fits my 5/8" bearings on the inside.

This will be my steering axle. Needs to be about 10" in length.

Still need to find small sprocket to fit this od 1.5". To connect to steering wheel.
Attached Thumbnails
IMAG1575.jpg   IMAG1576.jpg  

2016 diygokart Contestant
The Following 2 Users Say Thank You to pRoFiT For This Useful Post:
ezcome-ezgo (02-07-2017), sideways (04-12-2017)